portdvd.blogg.se - Palm tree plaster craft painting

PALM TREE PLASTER CRAFT PAINTING FULL

Spray the palm frond art's backside with spray adhesive.

This enables the artwork corners to flatten over the arced switch plate corners.

At each of the picture corners, make a 3/8" cut inward toward the center.Remember there will be a rectangular middle area for the switch interrupting the art, so consider that for your placement.Decide on your art & trace it to size by using the switch plate as a pattern.Steps: Remember to begin by protecting your work space. Now you'll have a snazzy DIY Palm Tree craft desk set that really looks nice! Now you can add ribbon to accessorize any pieces wherever you feel will look good. Are you placing the Palm Charm on a cylinder? Before gluing gently bend the brass charm against the cylinder first, so it will fit properly.Be sure the charm's surface isn't upright while drying, or it could slide.Smear white glue on the back of the charm & stick it in place. Begin at the top edge to get it even, then smooth it downwards. Carefully place it on the sides of the container. Smear white glue onto the rear of the Ultrasuede.

Put your template onto your Ultrasuede piece.Use gold paint to evenly spray the container's entire outside & inside.Trim along the lines to finish the template.Take it off to draw lines with the straight edge, using the marks as your guide.

PALM TREE PLASTER CRAFT PAINTING FULL

If there's already a full label on a can, for example, that can be the template. Wrap the paper around the container, fitting it at the bottom.Wrap paper around the container, cutting it down to near the size for easier working. Make templates for cutting your Ultrasuede.Now find a place in your home decor for this bronzed palm artwork creation! Then immediately spray it with the silver-metallic paint.Get the water spray bottle & have the silver-metallic paint spray ready.Be sure to give it enough time, then spray it all over with the dark brown spray paint. The appearance should have a sculpted look when dry. Even more-so where the palm attaches to the base. Smear it over the palm, giving it texture. Be sure it's dry, then open the white glue.It needs to be able to securely stay upright without problems.Your plastic palm should hopefully have a small base already for better adhesion to the larger base you're giving it.

Glue the bottom of the plastic palm onto the container lid.

For advance planning of which plastic fake palm to choose. Steps: Consider you'll attach the palm to the base made from the container lid. Making a Palm Leaf Mat DIY Palm Tree Craft Quick Tutorial Then be sure there's no wrinkling or curling by covering it for 24-48 hours with heavy books.

When happy with the look, let it completely dry.

Use the spray bottle to apply more "antiquing" liquid process to it. This will dry in a way to look more authentic And gently eek out lines of it across the art, to appear like cracks.

Use the pipettes to suck up some of the liquid, place two or three small puddles in areas of the artwork.

Then put the paperweights on the corners, just barely touching.

Carefully take the artwork out, place it flat onto the workspace newspapers.

Don't get it overly soggy so it falls apart, though!

Dip the artwork into the pan with the liquid, being sure it gets fully coated.

Pour the dark coffee/tea liquid you're using into the sheet pan.

Then use the ruler's straight edge to cut the severed side evenly. Carefully remove it by cutting with the scissors or craft knife.

Decide on the artwork from the book or magazine you'll use.

Have your work surface covered in old newspapers. Steps: Read these before beginning, so your plan is in mind.